Line Voltage 3.5 Inch Remodel with COB Reflector Retrofit NON-IC Housing
Features
Uniquely Designed for New and Existing Construction
Idea for Places Where Edison Base Sockets Have Been Banned
Environment Friendly no Cd or Hg included
Good Heat Dissipation More Safe to Use than LED Bulbs
LED Light Engine is attached to the die-cast heat sink and is easily replaceable and upgradable
High CRI>80%
50000 hours' life time
Spot Distribution is Idea for Task Lighting Applications
Housing
Die-formed aluminum for maximum heat dissipation and rust protection
Designed for New Construction installation and suitable for using in non-insulation covered ceilings
Housing adjusts to 1/2" to 1 3/8" ceiling thickness. Trims are held in place with high tension clips
Housing is Non-IC rated must be kept at least 3" away from insulation
Junction Box
ETL listed for through branch wiring
1/2" and 3/4" romex wiring knockouts and four romex knockouts with integral strain clamps, all knockouts have true pry-out slots
J-Box is designed for straight through conduit runs
Fixture fully assembled including pre-wired ballast for easy installation
Removable access plates for easy installation
Heat Sink
All our heat sinks are made of 6063 aluminum
Scientific design ensure good heat dissipation
Finish oxidize black color
Reflector Trim
Especially designed for COB light no glare
No visible hardware
All reflector trims using 3002 aluminum ensure good color consistency even though after long time high temperature working
Transmittance>90%
Durability
Die-cast system pulls heat from the LED chip allowing continued cool operation for years
LED output will be maintained at 70% if initial lumens at 50000 hours of operation
Our superior design allows for installation in construction where Air-ShutTM is required
Thermal Protection
Standard thermal protection device guards against improper installation and misuse of insulation material
LED Light Engine & Electronic System
120V/277V 50/60Hz input
Less than 20% THD will be produced
Power Factor>90%
Thermally protected for additional safety
Driver is installed on the junction box cover easy accessible for service from the ceiling
Class 2 power supply
Over voltage, over current and short circuit protection: Auto recovery
Dims down to 10% with electronic low voltage (ELV) reverse phase control dimmers
CRI>80%
Color Temperature 2700K-6500K
Cree, Citizen, Epistar all are available
16W max